Intermec PK80 User Manual download pdf (Page 32)

OperationChapter —2

20 PK80 Series 80-Column User’s Manual

Adjust t he Pinfeed Holders

Note: There are two pinfeed holders, one next to the green thumb wheel

and one opposite the same wheel. Always loosen the pinfeed holder oppo-

site the green thumb wheel.

Adjusting the pinf eed holder next to the green thumb wheel may cause

information to print in the wrong place. If this pinfeed holder is moved,

correct its location by r eleasing the pinfeed holder tab, moving the pinfeed

holder as close to the green thumb wheel as possible, then locking the

pinf eed holder tab, before adjusting the opposite pinfeed holder.

If the paper does not properly fit on the two pinfeed holders Follow these

steps to adjust the area between the two pinfeed holders to fit the width of

the paper. See the illustration on the next page.

1 With the pinfeed holders open, release the locking tab on the pinfeed

holder opposite the green thumb wheel.

2 Adjust the pinfeed holders to align the pins with the paper .

3 Close the pinf eed holder.

4 Ensure that the paper is smooth (no f olds, bulges, bows, etc.) between

the pinfeed holders. If so, push the locking tab down on the pinfeed

holder that you adjusted.

1 Pinfeed holder

2 Locked p infeed holder locking tab

3 Releas ed pinfeed holder locking tab

4 Thumb wheel (green)

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 83 84

No comments

Intermec PK80 User Manual Page 32