Intermec SR30 User's Guide download pdf (Page 53)

Appendix B — Default Settings

SR30 Handheld Scanner User’s Guide 43

Tolerance No tolerance

Beeps/green indicator LED

Volume High

Note (tone frequency) High (2090 Hz)

Power-up beeps/Power-up LED On

Good read beeps

Number 1

Duration 80 ms

Timing Before transmission

Good read LED duration 80 ms

Error beep On

Setup beep On

Bad read message Not active

Default=“NOREAD”

Operating Setting Commands (continued)

Command Default Value

Note: The next table applies to area imagers only.

Imager Setting Commands

Command Default Value

Pre-defined imager settings

1D codes only N/A

Standard 1D and 2D codes N/A

1D and 2D codes, bright environment N/A

1D and 2D codes with reflective surface N/A

General

Aimer flashing Aimer flashing

(optimized for

decode)

Decode mode 2D imager

1 2 ... 48 49 50 51 52 53 54 55 56

Comments to this Manuals

No comments