Intermec CK3A User Manual download pdf (Page 89)

Chapter 4 — Troubleshooting and Maintaining the CK3

CK3 Mobile Computer User’s Manual 77

Resetting the CK3

You seldom need to reset the CK3. However, you do need to reset the

CK3 when an application is locked up and does not respond, when

you upgrade the firmware, or when you reflash the CK3. The CK3

uses the configuration currently saved in flash memory during the

reset process.

There are three ways to reset the CK3:

• Warm boot

• Cold boot

• Clean boot

Warm Booting the CK3

If your CK3 has a charged battery installed but does not resume after

you press the Power key, or if the computer or an application is locked

up, you may need to warm boot the CK3.

To warm boot your CK3

• Press and hold for 5 seconds.

Or,

• From the SmartSystems console, right-click the CK3 and select

Intermec Power Tools > Warm Boot Device.

The CK3 shuts down, restarts, and goes through the initialization

process.

Cold Booting the CK3

If the CK3 or application is locked up and does not respond to a warm

boot, follow this procedure to perform a cold boot.

Performing a cold boot may result in data loss. When you

cold boot the CK3, cached disk data may not be saved, so

transactional data may be lost.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 135 136

No comments

Intermec CK3A User Manual Page 89