Intermec CN30 User Manual download pdf (Page 148)

Chapter 3 — Configuring the CN30

136 CN30 Mobile Computer User’s Manual

5 For Encryption, select “WEP” and press Enter.

6 Select User Name, type your user name, then press Enter.

7 Select User Password, type a user password, press Enter, then exit the

Intermec Settings applet.

Using Static WEP Security

The CN30 Computer uses the Wired Equivalent Privacy (WEP) protocol

to add security to your wireless network based on the 802.11b standard. To

use WEP security, you need a CN30 Computer with an 802.11b/g radio

and an access point with an 802.11b/g radio.

Configuring Static WEP Security With Funk Security

Use this procedure to set Static WEP security on your CN30 Computer

with Funk security.

1 Make sure you have configured the communications and radio parame-

ters on your CN30 Computer and that Funk is your security choice.

2 Open Intermec Settings. Tap (+) to expand Communications > 802.11

Radio > Funk Security > Profile X with “X” being “1” through “4.”.

3 For Association, select “Open” and press Enter.

4 For Encryption, select “WEP” and press Enter.

5 For 8021x, select “None” and press Enter.

7 For Transmit key, define a value for each key, up to four. Enter an ASCII

key or a hex key that is either 5 bytes or 13 bytes long depending on the

capability of the radio. Set a 5-byte value for 64-bit WEP or a 13-byte

value for 128-bit WEP. Hex keys must be preceded by 0x and contain 5

or 13 hex pairs.

8 Exit the Intermec Settings applet.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 195 196

No comments

Intermec CN30 User Manual Page 148