Chapter 3 — Configuring the CN30
CN30 Mobile Computer User’s Manual 153
To enable LEAP with Network EAP:
1 Set 8021x Security as “LEAP.”
2 Set Association to “Network EAP.”
3 Set Encryption to either “WEP” or “CKIP.”
4 Enter your unique Username to use this protocol.
5 Select Prompt for password to have the user enter this password each
time to access the protocol, or leave Use following password as selected
to automatically use the protocol without entering a password.
Advanced
Use this page to configure additional settings for this profile.
• Detect Rogue APs:
Wireless NICs and APs associate based on the SSID configured for the
NIC. Given an SSID, the BSSID with the strongest signal is often cho-
sen for association. After association, 802.1x authentication may occur
and during authentication credentials to uniquely identify a user - these
are passed between the NIC and the AP.
The base 802.1x technology does not protect the network from “rogue
APs.” These can mimic a legitimate AP to authentication protocols and
Comments to this Manuals