Intermec EASYCODER PD4 User Manual download pdf (Page 91)

Intermec EasyCoder PD4—User’s Guide 81

Appendix B—Media Speciﬁcations

Tickets with Black Mark

⇐ a ⇒ Media Width

Maximum: 118.0 mm (4.65 inches)

Minimum: 25.0 mm (1.00 inches)

⇐ b ⇒ Copy Length

Maximum:

8 dots/mm (203.2 dpi) 1270 mm (50 inches)

11.81 dots/mm (300 dpi) 558.8 mm (22 inches)

Minimum:

8 dots/mm (203.2 dpi) 10 mm (0.39) inches)

11.81 dots/mm (300 dpi) 10 mm (0.39) inches)

⇐ c ⇒ Detection Position

Variable: 0 to 57 mm (0 to 2.24 inches)

⇐ d ⇒ Black Mark Width

e detectable width of the black mark should be at least 5.0 mm (0.2

inches) on either side of the LSS detection point.

⇐ e ⇒ Black Mark Length

Maximum: 25 mm (0.98 inches)

Common: 5 mm (0.2 inches)

Minimum: 3 mm (0.12 inches)

⇐ f ⇒ Black Mark Y-Position

It is recommended that you place the black mark as close to the front

edge of the ticket as possible and use a negative Stop Adjust value to

control the media feed, so the tickets can be properly torn oﬀ.

Paper Type Setup

• Black mark

Note: Preprint that may interfere with the detection of the

black mark should be avoided.

Note: e black mark should be non-reﬂective carbon black on

a whitish background. Do not allow any perforations to break

the edge of the media as this may cause the media to split and

jam the printer.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 99 100

No comments

Intermec EASYCODER PD4 User Manual Page 91