Intermec SR31T HP User's Guide download pdf (Page 23)

Chapter 2 — Scanning with the SR31T Tethered Scanner

SR31T Tethered Scanner User’s Guide 15

By default, when the SR31T successfully reads a bar code, it beeps

once, the status light briefly turns green, and the scanner beam

turns off. If Vibrate Alert is enabled, the scanner briefly vibrates.

3 Release the trigger.

Scanning Bar Codes: The aiming and scanner beams that you see depend on

which SR31T model you are using.

To scan with an SR31T 2D imager model (2D or HP)

1 Point the scanner at the bar code and hold the SR31T steady a few

inches from the label.

2 Pull the trigger and use the laser framing or aiming beam to

position the imager over the bar code or area to capture.

Use this test bar code:

Code 39 Test Bar Code

*123456*

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 71 72

No comments

Intermec SR31T HP User's Guide Page 23