Intermec CN3 User Manual Page 36

  • Download
  • Add to my manuals
  • Print
  • Page
    / 212
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 35
Chapter 1 — Using the Computer
22 CN3 Mobile Computer User’s Manual
Adjusting the Volume
The volume is enabled when you adjust the volume. You can control the
volume by pressing the two scan buttons on the right side of the CN3 as
shown above, using the Volume drop-down in the toolbar, or the Intermec
Settings applet.
In either situation, tap Off to disable the volume.
To adjust the volume for the rear speaker
To use the Intermec Settings applet to adjust the volume
1 Tap the Volume icon at the top of the screen.
2 Tap On, then move the system volume slider to the desired volume level.
Up is louder, down is quieter.
If your CN3 comes with a phone, be sure to use the left slider bar for the
volume for the rear speaker, and to use the right slider bar for the phone
(front speaker).
1 Tap Start > Settings > the System tab > the Intermec Settings icon.
2 Tap (+) to expand Device Settings > Beeper > Volume.
3 Tap any of the options other than “Off” to enable and adjust.
Phone slider barVolume slider bar
Page view 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 211 212

Comments to this Manuals

No comments