Intermec SR31T HP User's Guide download pdf (Page 29)

Chapter 3 — SR31T Interfaces

SR31T Tethered Scanner User’s Guide 21

2 Connect the power supply to the cable and an AC power outlet if

you are using the externally powered USB cable.

3 If your host device is off, turn it on. The scanner beeps twice, the

green LED flashes to indicate the USB interface being used and

the scanner vibrates (see the Understanding the Lights and

Understanding the Beeps and Vibrate Alert explanations in

Chapter 2).

4 If necessary, use the configuration bar codes in the next section to

configure your SR31T for an International keyboard. The default

keyboard is North America.

USB cable with power jack

Note: If you are using a non-powered USB cable, you may get a

message that the host does not provide enough power. For example

when you connect the USB cable to a keyboard hub or if there are

other USB devices connected. In this case use a different hub or

disconnect other USB devices. Otherwise use a powered USB cable.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 71 72

No comments

Intermec SR31T HP User's Guide Page 29