Intermec SR31T HP User's Guide download pdf (Page 39)

Chapter 3 — SR31T Interfaces

SR31T Tethered Scanner User’s Guide 31

Wand Emulation

The SR31T can be connected to a host using a wand emulation cable.

See the “SR31T Cable List” on page 6 for a list of part numbers for

the different cables. The type of cable depends on the host device or

intermec computer your are using. No power supply is necessary.

Connecting a Wand Emulation Cable

To create a wand emulation connection

1 Turn off your host device or Intermec computer.

2 Connect the wand emulation cable to your SR31T and the host or

Intermec computer.

3 If necessary, use the configuration bar codes in the next section to

configure your SR31T for wand emulation interface.

Setting up the Wand Emulation Interface

This section provides configuration bar codes for a basic setup. All bar

codes marked with (*) indicate the default value. For more

configuration options see Chapter 4, "Configuring the SR31T

Scanner” on page 33.

Logical Signal State During Transmission

Bar = 0, Space = 1 (*)

Bar = 1, Space = 0

Note: When using a wand emulation connection the postamble and

preamble are not available.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 71 72

No comments

Intermec SR31T HP User's Guide Page 39