Intermec SR31T HP User's Guide download pdf (Page 50)

Chapter 5 — Troubleshooting and Maintaining the SR31T

42 SR31T Tethered Scanner User’s Guide

Rescuing the SR31T

You can rescue your SR31T if you cannot configure it anymore

because it is in a locked configuration. This can happen if you

inadvertently disabled the trigger for example.

To rescue your SR31T

1 Disconnect your product from its electrical power (disconnect the

cable from the product).

2 With the product disconnected, use your usual operating hand to

pull and hold the trigger.

3 Do not release the trigger while you reestablish electrical power

(reconnect the cable).

The scanner acknowledges power-up (beeps, LEDs and vibrate

alert).

4 Keep the trigger pulled around 10 seconds until the red LED lights

up.

5 Pull the trigger very rapidly five times in succession while the red

LED is on (you need to be quick as the red LED only stays on for 2

seconds). 

The green LED comes on and the scanner beeps a reset

confirmation (beep melody), then acknowledges power-up again

(beeps, vibrate alert).

Note: When you rescue your scanner, factory default settings are

restored including custom default settings. Rescuing the scanner is

also a way to force a factory reset if you do not have access to a

Reset

factory defaults

configuration code or a PC with EasySet.

Note: If your scanner still does not operate correctly after a rescue

procedure, contact your Intermec Product Support representative (see

Calling Product Support in the next section).

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 71 72

No comments

Intermec SR31T HP User's Guide Page 50