Intermec PD41 User Manual download pdf (Page 60)

Chapter 3 — Configuring the Printer

46 PD41 and PD42 Commercial Printer User’s Manual

4 Click Submit Settings.

Use the following table to understand the Alert Settings.

Understanding the Alert Settings

Setting Description

Label Not Taken

(Fingerprint only)

Sent when the printed label is not taken from the

printer. This setting applies to label and ticket media

and requires an optional label taken sensor.

Cutter Error There was an error related to the label cutter.

Head Lifted A printer job was sent to the printer while the

printhead was lifted.

Out of Ribbon You have thermal transfer ribbon selected and the

printer is out of ribbon.

Pause Mode The printer is in Pause mode.

Setup Mode The printer is in Setup mode.

Error Condition

(Fingerprint only)

An error has occurred in the Fingerprint application.

The error does not have to be critical to the print job

for the printer to send this alert.

Application Break

(Fingerprint only)

A running Fingerprint application has been

interrupted manually or because of an error.

Print Job Complete

(Fingerprint only)

The print job has been successfully completed.

Odometer Count 1 The amount of media printed has reached a preset

amount, measured in meters or in number of labels.

The Delay repeat setting represents how often the

alert message will be sent when the preset value is

reached.

Notification Method The method used to send an alert message. You can

choose from mail, SNMP-trap, or both.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 161 162

No comments

Intermec PD41 User Manual Page 60