Intermec PD41 User Manual download pdf (Page 87)

Chapter 4 — Troubleshooting and Maintaining the Printer

PD41 and PD42 Commercial Printer User’s Manual 73

Printable characters are printed in black-on-white. Control characters

and space characters (ASCII 000 to 032 dec) are printed in white-on-

black.

As long as a continuous string of characters is being received, the

program wraps the lines until the label is full and then starts to print

another label. After each character transmission, the following

information prints:

• Page number

• Number of characters printed on the label

• Total number of characters received so far

When you exit Dump mode, a final label prints to inform you that it

exited Dump mode.

Using Dump Mode

When you enter Dump mode, the printer captures incoming

characters on the communications ports and prints them on one or

more labels.

You can access Dump mode in two different ways with slightly

different results:

• You can access Dump mode through Test mode or Extended Test

mode and you will receive printouts that look exactly like those

produced with the Line Analyzer program in Fingerprint. For

more information, see the previous procedure, “Using the Line

Analyzer in Fingerprint” on page 72.

• You can access Dump mode from the Setup menu on the PD42

and characters will print on a continuous line, along with

corresponding hexadecimal numbers.

To enter Dump from the Setup menu on the PD42

1 Press to enter Setup mode.

2 Navigate to Test/Service> Data Dump.

3 Toggle to Yes and then press .

The printer is now in Dump mode.

To exit Dump mode

• Turn the printer off and then back on again.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 161 162

No comments

Intermec PD41 User Manual Page 87