Intermec PD41 User Manual download pdf (Page 62)

Chapter 3 — Configuring the Printer

48 PD41 and PD42 Commercial Printer User’s Manual

Configuring Mail Settings

Use the mail settings page to view and change email (SMTP) server

settings.

To configure mail settings

1 Click Network Admin > Mail.

2 Select the mail server settings and enter mail addresses.

3 Click one of these buttons:

• Submit Mail Settings to send the changes to the printer.

• Submit & Send test mail to send the changes to the printer

and test your new settings.

Use the following table to understand the mail settings.

Restrictions Sets restrictions on who is allowed to upgrade

the printer firmware or view and change

network settings. You cannot remove “admin”

from the list of authorized users.

Users allowed to update: Defines who may

perform a firmware upgrade using FTP,

PrintSet, or IFAB. This setting does not affect

upgrading from a Compact Flash card.

Users allowed to read/write protected LAN1

settings: (Fingerprint only) Defines who may

read/write settings in the LAN1 section.

Users allowed to change network settings:

(Fingerprint only) Defines who may change the

network node in the setup. This setting is not

supported if you are setting up the printer from

its internal keyboard.

Users allowed to change wireless settings:

Defines who may change WLAN or 802.1x

settings.

Understanding the General Network Settings (continued)

Setting Description

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 161 162

No comments

Intermec PD41 User Manual Page 62